COLORBOND® Stramit Monoclad® Roof and Wall Sheet Cladding
$18.45Original price was: $18.45.$15.45Current price is: $15.45.
Buy Stramit Monoclad® Roof and Wall Sheeting Online
Fast order processing and delivery times are guaranteed.
Stramit’s Monoclad roof and wall sheet profile is suitable for wall cladding the external roof and walls of your home, office, shed, or any class 1a and class 10 building.
A versatile cladding solution, Monoclad® features a balanced design, water-carrying capacity, wind load performance, and simple fixing.
Stramit Monoclad® Roof and Wall Cladding can be fixed with four fasteners per sheet at each batten/purlin to meet the required performance values.
Class 4 fasteners should be used when less than 1km from the coast and susceptible to salty air or in a corrosive environment.
What fixing screws should I use for Stramit’s Monoclad®?
Use Bremick SDM ROOF 12-14×51 Hex Class 4 (B8) Top Grip™ when screwing to purlin.
Use Bremick Vortex 6.2-13×50 Hex Class 4 (B8) Top Grip™ when fixing to metal battens up to 1.5mm.
Use Bremick Vortex 6.2-13×65 Hex Class 4 (B8) Top Grip™ when fixing to timber.
720mm wide coverage and priced per lineal meter (l/m),
The 29mm rib profile design offers superior spans and water-direction capacity
The lap joint system allows for single-plane, long-run roofs utilising the compatible Stramit Monolap®
Suitable for 2-degree minimum roof pitch for low pitch or skillion roof buildings.
Base Material Thickness (mm): 0.42 and 0.48Finish available in both COLORBOND® and ZINCALUME®
Stramit Monoclad® Roof and Wall Cladding gives excellent durability in almost all locations. However, choosing the correct coating for each application environment is essential, as shown in the table below. Durability recommendations vary based on the application of the product in roofing or walling installations. Please read these tables carefully.
The roofing/walling shall be 0.42 (or 0.48) mm BMT Stramit Monoclad® Roof and Wall Cladding in continuous lengths with trapezoidal ribs approximately 29mm high, spaced at 190mm centres. The sheeting material shall be protected steel sheet to Australian Standard AS1397, with a minimum yield stress of 550MPa (Grade G550) and an AM100/AZ150 coating with an oven-baked paint film of selected colour or a plain AM125/AZ150 coating.
Following the manufacturer’s recommendations, the sheeting shall be fixed to the purlins/girts. Suitable fixing screws following Australian Standards AS3566, Class 3, shall be used at every rib at every support with side lap fasteners installed at mid-span if required. Sheets shall be laid in such a manner that the approved side lap faces away from the prevailing weather. A minimum of 50mm shall be provided for projection into gutters. Flashings shall be supplied in compatible materials as specified; the minimum flashing cover shall be 150mm.
All sheeting shall be fixed in a workman-like manner, leaving the job clean and weathertight. Repair minor blemishes with touch-up paint supplied by the roof manufacturer. All debris (nuts, screws, cuttings, filings etc.) shall be cleaned off daily.
Class 4 fasteners should be used <1km from the coast.
Reviews
There are no reviews yet.
Be the first to review “COLORBOND® Stramit Monoclad® Roof and Wall Sheet Cladding” Cancel reply
Reviews
There are no reviews yet.